Ürün Ara
Lütfen email adresinizi giriniz

Müşteri Yorumları

4.9 5 üzerinden
  • 18
  • 2
  • 0
  • 0
  • 0
Bir yorum yazın
  • Su
    Very good auto bed leveling system for Ender 3
    This is my second time when I set up BL touch clone device and it went flawlessly as before. Easy to mount on MKS GEN L board, perhaps the original Ender 3 control board need more tweaking to expose the right pins. Works very well to establish leveled bed.

    Apr 05,2019

  • Luis Alvarez
    auto level for 3d printer
    really good sensor, works perfectly with Anet a8 Andrés marlyn software, only do conect correctly the cables in board and calibrate the parameters for never leveling bed manually. I am very satisfied with this product.

    Jan 15,2019

  • Rui
    A simple clone that works
    As a clone I was wary of the quality, but until now it works has expected. And has it works as expected you hardly see it is there.I printed a fan shrowd that could accomodate the mounting screws, because my printer was not natively prepared to mount it.

    Dec 14,2018

  • Davide
    Il sensore arriva provvisto di diversi cavi e raccordi elettronici per fissarlo, alcuni cavi sono però troppo corti, ed il tutto non è proprio semplice da montare, manca anche una spiegazione che però si trova facilmente in internet

    Mar 21,2019

  • HelenAnouk
    Geee, this is good!
    This is the best addition you can buy for your 3D printer. No more fuss with a sheet of paper and manually levelling the printbed. After installation and a simple change in the firmware this levelling sensor does all the work for you.

    Mar 11,2019

  • lr
    Juste parfait
    L'accessoire indispensable pour toute imprimante 3d. Une fois installé les impressions sont simplifiées du tout au tout.

    Apr 30,2019

  • Marto
    A must-have
    I use this on my Anet A8, the wiring can be found on the internet. It is relatively easy to set up. After that bed leveling is not that intimidating and time consuming, it's so easy that you can do it before every print!

    Dec 14,2018

  • Daniel
    Originale? Penso di si.
    Originale? Penso di si.Non capisco perché c'è una resistenza all'interno del kit. Approposito il kit è fornito anche di connettori da collegare/saldare nel bisogno

    Dec 15,2018

  • sakiffi
    Great money
    Installation itself is pretty easy, even without any guidelines - internet is full of them for any specific printer out there. Calibration was total PITA, but what can you expect.

    Dec 25,2018

  • ISSU
    Geeetech® TL-touch 3D-Touch automata ágyemelő szenzor
    Gyors és sérülésmentes szállítás. Jó minőség, könnyen használható. Alig várom, hogy használhassam. Elégedett vagyok. Köszönöm.Fast and damage-free shipping. Good quality, easy to use. Can't wait to use it. I am pleased. Thanks.

    Oct 31,2019