Herşey
Ürün Ara
Lütfen email adresinizi giriniz

Müşteri Yorumları

4.86 5 üzerinden
  • 6
  • 1
  • 0
  • 0
  • 0
Bir yorum yazın
  • Eamonn
    3-Pin Screw Terminal Too Small For Rated Current of Relay
    Use with caution! The 3-Pin Screw Terminal at the output looks too small to support the 30 A rated current of the relay. Similar screw terminals I see have max ratings between 8 to 10 A. If you need to drive more than 10 A, it may be prudent to directly solder the output wires to the relay pins and not use the screw terminals.

    Jan 09,2019

  • Elton
    Fits the requirements
    Used with Arduino. Arduino 5v pin was insufficient current to drive the relays. I needed to provide a separate 5v supply. Once I understood this requirement, the relays have worked well. Able to connect 12Gauge wire to the high voltage terminals, as the terminals are sized large enough to accept this gauge.

    Dec 19,2018

  • Egbert
    Works great. It's handling 19 amps thru the NO and ...
    Works great. It's handling 19 amps thru the NO and 9.5 amps thru NC connections. handles 10 awg wire. Minimal heat. Had to externally power the ardunio to get it to trigger the relay. USB power was not enough.

    Jan 06,2019

  • JP
    Good quality product
    Used for discreet transistor output protection with smart house project. Quite good quality, soldering and design.

    Feb 02,2019

  • Thomas
    great
    Goods: good quality, affordable, practical.
    Service: The service attitude is good and worth trading.

    Jan 15,2019

  • Colleen
    very good
    easy to use, very good, quick response, no need to design your own circuit

    Jan 13,2019

  • George
    good buy
    Works well.

    Dec 14,2018